Lexmark C912 Setup Guide - Page 38
Step5: Install memory and option cards, Removing the system board access cover - firmware
View all Lexmark C912 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
Step 5: Install memory and option cards CAUTION: If you are installing memory or option cards after initial printer setup, turn the printer off and unplug the power cord. If you have any other devices connected to the printer, turn them off as well and unplug any cables going to the printer. If you did not purchase any memory, firmware, or option cards, skip this step and go to "Step 6: Load paper" on page 38. You can customize your printer memory capacity and connectivity by adding option cards or a hard disk. Removing the system board access cover You must remove the system board cover to install memory cards, a firmware card, a hard disk, or an option card. You need a number 2 Phillips screwdriver to remove the system board cover. Rear cover Install memory and option cards 29