Lexmark C912 Setup Guide - Page 42

Installing a firmwarecard

Get Lexmark C912 PDF manuals and user guides View all Lexmark C912 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 42 highlights

Installing a firmware card Note: Firmware cards designed for other Lexmark printers may not work with your printer. Warning: Firmware cards are easily damaged by static electricity. Touch something metal, such as the printer frame, before you touch a card. Alignment pins If an option card has been installed, you need to remove the option card before installing the firmware card. 1 Remove the system board access cover (see page 29). 2 Unpack the firmware card. Avoid touching the metal pins on the bottom of the card. Save the packaging. System board holes 3 Holding the card by its sides, align the pins on the card with the holes on the system board. 4 Push the firmware card firmly into place. The entire length of the connector on the firmware card must touch and be flush against the system board. Be careful not to damage the connectors. Install memory and option cards 33

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
Installing a firmware card
Note:
Firmware cards designed for other Lexmark
printers may not work with your printer.
Warning:
Firmware cards are easily damaged by static
electricity. Touch something metal, such as the printer
frame, before you touch a card.
Alignment pins
System board holes
If an option card has been installed, you 
need to remove the option card before 
installing the firmware card.
1
Remove the system board access 
cover (see page 29).
2
Unpack the firmware card.
Avoid touching the metal pins on
the bottom of the card. Save the 
packaging.
3
Holding the card by its sides, align
the pins on the card with the holes 
on the system board.
4
Push the firmware card firmly into 
place.
The entire length of the connector
on the firmware card must touch
and be flush against the system 
board.
Be careful not to damage the 
connectors.
Install memory and option cards
33