LiftMaster LA100 LA100 Linear Gate Operator Manual - Page 13

2 MEASURING AND MARKING FOR THE GATE BRACKET Before proceeding, begin with the gate in the fully closed position. There are two methods described to determine proper location of the post brackets: • Paper template (to be cut out) located on the back page of this manual. • Tape measure. Either method will work depending on preference. NOTE: Be sure gate is in closed position before proceeding. Template Method Place the template (provided on the back page) under the gate hinge point. Use a screwdriver or dowel rod to temporarily mark the location in front of the gate post. LEFT SIDE BRACKET MOUNTING Gate Post Gate Hinge Point RIGHT SIDE BRACKET MOUNTING Gate Post Gate Hinge Point TOP VIEW TOP VIEW Gate Post Gate Post Use a screwdriver or dowel rod to temporarily mark measurement. Use a screwdriver or dowel rod to temporarily mark measurement. Tape Measure Method Place the measuring tape under the gate hinge point and measure 5-1/2". Use a screwdriver or dowel rod to temporarily mark the location of the first measurement. LEFT SIDE BRACKET MOUNTING RIGHT SIDE BRACKET MOUNTING Gate Post Gate Hinge Point Gate Post Gate Hinge Point Gate Post 5-1/2" X Measure 5 1/2" from the previous mark. Gate Post Gate Hinge Point 5-1/2" Gate Post Gate Hinge Point Gate Post X X X X 5-1/2" 5-1/2" Use the screwdriver or dowel rod to mark the location of the second measurement. Gate Post Gate Hinge Point Gate Post Gate Hinge Point X First Marking 13 First Marking Installation