LiftMaster LA100 LA100 Linear Gate Operator Manual - Page 26

OPERATION AND MAINTENANCE NG IMPORTANT SAWFAERTYNININGSTRUCTIONS N WARNING To reduce the risk of SEVERE INJURY or DEATH: 1. READ AND FOLLOW ALL INSTRUCTIONS. 5. Use the emergency release ONLY when the gate is not 2. NEVER let children operate or play with gate controls. moving. Keep the remote control away from children. 6. KEEP GATES PROPERLY MAINTAINED. Read the owner's 3. ALWAYS keep people and objects away from the gate. NO manual. Have a qualified service person make repairs to ONE SHOULD CROSS THE PATH OF THE MOVING GATE. gate hardware. 4. Test the gate operator monthly. The gate MUST reverse 7. The entrance is for vehicles ONLY. Pedestrians MUST use on contact with a rigid object or stop when an object separate entrance. activates the non-contact sensors. After adjusting the 8. Disconnect ALL power BEFORE performing ANY force or the limit of travel, retest the gate operator. Failure maintenance. EMENT to adjust and retest the gate operator properly can AVERTISSSEAMVEENTTHESE increase the risk of INJURY or DEATH. 9. INSTRUCTIONS. Operation ON REMOTE CONTROL AVERTISSEMENT When the gate is in the closed position, activation of the remote control button will open the gate. During the open cycle, another activation of the remote control button will stop the gate and the next activation will close the gate. When the gate is in the open position, activation of the remote control button will close the gate. During the close cycle, another activation of the remote control button will stop the gate and the next activation will open the gate. SINGLE BUTTON CONTROL Operates the same as the remote control. NOTE: If the TIMER-TO-CLOSE feature is enabled, it will be temporarily disabled after an obstruction is encountered. It will take a user command to re-enable. (E2) Double Obstruction Encounter: If the gate encounters two consecutive obstructions, the gate will stop and no longer respond to any commands. An alarm will sound continuously for 5 minutes, alerting the user of a possible problem. To resume normal operation, the user must remove the obstruction and then press the RESET button located on the control box. SAFETY SENSORS If the sensors are obstructed with the gate in any stopped position they will not allow the gate to open or close. While the gate is moving in the open or close direction and the safety sensors are obstructed, the gate will immediately stop and once the obstruction has been NCIA ADVERTENCIA cleared, the next run command will continue the gate in the same direction. RESET NOTE: If the TIMER-TO-CLOSE (TTC) option is enabled IÓN ADVERTENCIA and an obstruction occurs while the gate is closing, the gate will stop and the TTC will be temporarily disabled Reset Button RESET until the next run command is given. If the gate is fully open and the sensors are obstructed, once the obstruction is no longer present, the TTC will be enabled and the gate will close after programmed time. PRIMARY ENTRAPMENT PROTECTION SYSTEM (OBSTRUCTION ENCOUNTERS) The system has the ability to stop and reverse if the gate encounters an obstruction. (E1) Single Obstruction Encounter: If the gate contacts an obstruction while closing or opening, the gate will automatically reverse direction and stop on the open or close limit setting. Operation and Maintenance 26