LiftMaster LA100 LA100 Linear Gate Operator Manual - Page 23

Adding Additional Wireless Control Devices The gate controller has the ability to learn 9 (total) wireless control devices such as additional remote controls or keyless entry (see accessories): To add additional Remote Control: 1. Press and release the PURPLE button on the control board. The YELLOW LED will light continuously. The gate controller is now ready to learn a new remote control. 2. Press and hold the desired button on the additional remote control until the YELLOW LED on the control board goes out. To add Keyless Entry Control (not provided): 1. Press and release the PURPLE button on the control board. The YELLOW LED will light continuously. The gate controller is now ready to learn password. 2. Within 30 seconds enter a four digit personal identification number (PIN) then press the ENTER button for approximately 3 seconds and release. The YELLOW LED on the control board will go out. (Temporary PIN's are not available for use with this gate operator) NOTE: If no radio signal is detected within 30 seconds, the learn mode will exit automatically. To clear programmed remotes, press and hold the PURPLE button until the YELLOW LED goes out (about 6 seconds). This will clear ALL learned wireless control devices. NOTICE: To comply with FCC and or Industry Canada (IC) rules, adjustment or modifications of this receiver and/or transmitter are prohibited, except for changing the code setting or replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS. Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Optional Control Connections SINGLE BUTTON CONTROL A wired control that functions identically to the wireless remote control can be connected to the SWITCH +/inputs on the control board. Any switch with normally open contacts and a momentary input can be used. Be sure to unplug the Power Supply before making any electrical connections to the control board. Advanced Programming Features PROGRAMMING TIMER TO CLOSE (TTC) Timer to close is a user programmable option that will automatically close the gate after this feature has been programmed. 1. Begin with the gate in the fully closed position, press and hold the BLACK button for 2 seconds then release when the YELLOW LED turns on solid. 2. Press the BLACK button X amount of times to set the desired close delay: 1 press = 15 seconds (LED will blink 1 time) 2 press = 30 seconds (LED will blink 2 time) 3 press = 45 seconds (LED will blink 3 time) 4 press = 60 seconds (LED will blink 4 time) 5 press = 75 seconds (LED will blink 5 time) 6 press = 90 seconds (LED will blink 6 time) 7 or 0 press = TTC off (LED will turn on solid and then go out after 10 seconds) 3. After programming the X amount of time desired, allow 10 seconds for TTC programming to exit. You will hear a single beep from the alarm that indicates programming has exited. NOTE: If the gate is open and the power is interrupted, the TTC will be disabled. Upon another user command the timer to close will be reactivated. PARTY MODE This feature allows the user to temporarily disable TTC. With the gate in the open position, simply press and release the RESET button located on the outside of the control box. The gate will remain open until a user command is given. E / OPEN R6 R17 S1 RESET JU1 ALARM WHT BRN GRN YEL +_ _+ IR SWITCH +_ _+ IR SWITCH 23 Programming