Marantz SR7008 Owner's Manual in English - Page 182

Contents Connections Playback Input Select Set the audio input mode and decode mode of each input source. The input modes available for selection may vary depending on the input source. 22Input Mode Set the audio input modes for input sources. It is normally recommended to set the audio input mode to "Auto". Auto (Default) : Automatically detect input signal and perform playback. HDMI : Play only signals from HDMI input. Digital : P lay only signals from digital input. Analog : Play only signals from analog input. 7.1CH IN : Only signals input from the 7.1CH IN connector will be played back. % • When digital signals are properly input, the ~ indicator lights on the display. If the ~ indicator does not light, check "Input Assign" (vpage 179) and the connections. • If "HDMI Control" is set to "On" and a TV compatible with the ARC is connected via the HDMI MONITOR connectors, the input mode whose input source is "TV AUDIO" is fixed to ARC. • The sound mode cannot be set if the input mode is set to "7.1CH IN". Settings Tips Appendix 22Decode Mode Set the audio decode mode for input source. Auto (Default) : Detect type of digital input signal and decode and play automatically. PCM : Decode and play only PCM input signals. DTS : Decode and play only DTS input signals. % • This item can be set for input sources for which "HDMI" or "DIGITAL" is assigned at "Input Assign" (vpage 179). • Normally set this mode to "Auto". It is recommended to set "PCM" or "DTS" when audio is missing at the beginning or a noise occurs. Front panel Display Rear panel 182 Remote Index