Marantz SR7008 Owner's Manual in English - Page 198

Contents Connections Playback Bass Set subwoofer and LFE signal range playback. 22Subwoofer Mode Select low range signals to be reproduced by subwoofer. LFE (Default) : The low range signal of the channel set to "Small" speaker size is added to the LFE signal output from the subwoofer. LFE+Main : The low range signal of all channels is added to the LFE signal output from the subwoofer. This is usually the best setting for most systems. % • "Subwoofer Mode" can be set when "Speaker Config." - "Subwoofer" (vpage 194) is set to other than "None". • Play music or a movie source and select the mode offering the strongest bass. • If "Front" and "Center" for "Speaker Config." (vpage 193) are set to "Large", and "Subwoofer Mode" is set to "LFE", no sound may be output from the subwoofers, depending on the input signal or selected sound mode. Select "LFE+Main" if you want the bass signals to always be produced from the subwoofer. 22LPF for LFE Set LFE signal playback range. Set this when you want to change the playback frequency (low pass filter point) of the subwoofer. 80Hz / 90Hz / 100Hz / 110Hz / 120Hz (Default) / 150Hz / 200Hz / 250Hz Settings Tips Appendix Impedance Set the impedance of connected speakers. 8Ω/ohms (Default) : Select when the impedance per speaker for all the connected speakers is 8 Ω/ohms or larger. 6Ω/ohms : Select when the impedance for any of the connected speakers is between 6 Ω/ohms and 8 Ω/ohms. % • Check the speaker impedance (Ω/ohms) shown on the back of your speakers or in the instruction manual beforehand. Front Speaker Set the front speaker A/B to use for every sound mode. % • This can be set when "Assign Mode" (vpage 192) is set to "7.1ch + Front B". A (Default) : Front speaker A is used. B : Front speaker B is used. A+B : Both front speakers A and B are used. % • This can be set by pressing SPKR A/B on the main unit. Front panel Display Rear panel 198 Remote Index