Marantz SR7008 Owner's Manual in English - Page 221
Delete saved remote control codes, Delete remote control codes for each button
View all Marantz SR7008 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 221 highlights
Contents Connections Playback 5 Press and hold the button that you want to register on the other remote control until "OK" is displayed on the Marantz remote control display. • If "NG" is shown on the remote control display, perform step 4 again. 6 Repeat steps 4 and 5 to learn other buttons for the same input source. 7 When programming of the remote control unit is completed, press SET. The LEARN indicator turns off, and the remote control unit exits learn mode. % • There are some remote control units that cannot be programmed, or even if they can be programmed, they may not operate correctly. If this happens, use the remote control unit supplied with the AV equipment to operate it. • If the remote control memory becomes full, "FULL" is shown on the remote control display. If you want to learn the code, you should erase other learned button. NOTE • The learning function is unavailable for all ZONE SELECT, SET, AVR, POWER X, VOLUME df, FAVORITE STATION, SOUND MODE and input source select buttons in any mode. • If no buttons are pressed for approximately 1 minutes while in the LEARN mode, the remote control unit automatically exits from the LEARN mode. Settings Tips Appendix Delete saved remote control codes Codes can be erased in three ways: by buttons, sources, and by all memory contents. 22Delete remote control codes for each button 1 Press and hold SET until the LEARN indicator blinks. 2 Press input source select buttons to select the input source you want to delete. The input source is shown in the remote control display. 3 Press and hold POWER X and press the learned button to be erased twice. "ERASE" is shown in the remote control display. 4 Press SET. • The LEARN indicator turn off. Front panel Display Rear panel 221 Remote Index