Motorola LS3408-FZ20005 User Manual - Page 23

Getting Started 1 - 5 Connecting a Synapse Cable Interface NOTE Refer to the Synapse Interface Guide provided with the Synapse cable for detailed setup instructions. Synapse Smart Cables enable interfacing to a variety of hosts. The appropriate Synapse cable has the built-in intelligence to detect that host. To host Synapse Smart Cable Synapse adapter cable To scanner Figure 1-5 Synapse Cable Connection 1. Plug the Synapse adapter cable into the bottom of the scanner, as described in Installing the Interface Cable on page 1-3. 2. Align the 'S' on the Synapse adapter cable with the 'S' on the Synapse Smart Cable and plug the cable in. 3. Connect the other end of the Synapse Smart Cable to the host. Removing the Interface Cable 1. Loosen the two screws on the cable clamp at the bottom of the scanner and gently pull the clamp away from the bottom of the scanner. 2. Open the clamp and unplug the interface cable modular connector from the cable interface port on the bottom of the scanner handle. Carefully slide out the cable. 3. Follow the steps for Installing the Interface Cable on page 1-3 to connect a new cable. Configuring the Scanner Use the bar codes in this manual or the 123Scan configuration program to configure the scanner. See Chapter 4, User Preferences and each host chapter for information about programming the scanner using bar code menus. See Chapter 11, 123Scan to configure the scanner using this configuration program. The 123Scan program includes a help file.