Motorola LS3408-FZ20005 User Manual - Page 26

2 - 2 Symbol LS3408 Product Reference Guide Beeper Definitions The scanner emits different beeper sequences and patterns to indicate its status. Table 2-1 defines beep sequences that occur during both normal scanning and while programming the scanner. Table 2-1 Standard Beeper Definitions Beeper Sequence Indication Standard Use Short low/short medium/short high beep sequence Power up. 1 short high beep A bar code symbol was decoded (if decode beeper is enabled). 4 long low beeps A transmission error was detected in a scanned symbol. The data is ignored. 5 long low beeps Conversion or format error. Short high/short high/short high/long low RS-232 receive error. beep sequence Parameter Menu Scanning Long low/long high beep sequence Incorrect programming sequence or Cancel bar code scanned. Scanner remains in program mode. Short high/short low beep sequence Keyboard parameter selected. Enter value using bar code keypad. Short high/short low/short high/short low Successful program exit with change in the parameter setting. beep sequence Short low/short high/short low/short high Out of host parameter storage space. Scan Set Default Parameter on beep sequence page 4-3. USB only 4 short high beeps Scanner did not complete initialization. Wait several seconds and scan again. Short low/short medium/short high beep sequence after scanning a USB Device Type. Communication with the bus must be established before the scanner can operate at the highest power level. Short low/short medium/short high beep sequence occurs more than once. The USB bus may put the scanner in a state where power to the scanner is cycled on and off more than once. This is normal and usually happens when the PC cold boots. RS-232 only 1 short high beep A character is received and Beep on is enabled.