Netgear FSM7328PS FSM7328PS Hardware manual - Page 12
FSM7328PS Front Panel and LEDs, Table 2-2. LED Descriptions for FSM7328PS - software
UPC - 606449051810
View all Netgear FSM7328PS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Managed Stackable Layer 3 Fast Ethernet Switches Hardware Installation Guide FSM7328PS Front Panel and LEDs The following figure shows the front panel of the FSM7328PS. The front panel contains LEDs, RJ-45 jacks, SFP module bays, and stacking ports. ID PoE 1 L/A 3 5 7 9 11 13 15 17 19 21 23 Stack Master Link/ACT BPS Fan PWR MaxPoE RST PoE: Green=PoE Active Yellow=Poe Fault 2 4 L/A: Green=link at 100M Yellow+Link at 10M Blink=Activity 6 8 10 12 14 16 18 20 22 24 25 26 27 28 LEDs Figure 2-3 RJ-45 jacks SFP module bays Stacking ports The following table shows the LEDs on the front panel of the switch. Table 2-2. LED Descriptions for FSM7328PS LED ID Master Power Fan MAX PoE RPS (redundant power supply) Description This is the stack member ID (1-8) that the software assigns to the switch. Green: This switch is the master of the stack. Off: The switch is not the master of the stack. Solid green: Power is supplied, and the switch is operating normally. Blinking green: Runtime code load in progress. Solid yellow: Power-On Self-Test (POST) in progress. Blinking yellow: POST failure or CPU failure. Off: Power is disconnected. Solid red: Fan has failed. Off: Fan is present and operating normally. Solid yellow: Less than 15.4 W of PoE power is available. Blinking yellow: The MAX PoE LED was active in the previous two minutes. Off: There is at least 7 W of PoE power available for another device. Solid green: RPS bank supply PoE power. Off: RPS bank is disconnected. 2-4 Introduction v1.0, May 2007