Netgear GA622T GA622T Reference Manual - Page 15
Before installing your Gigabit Ethernet Card - copper gigabit ethernet card
UPC - 606449021561
View all Netgear GA622T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Table 2-2. GA622T LEDs Label Activity Description DATA Blinking On Off Brief bursts of data detected on the port Streams of data detected on the port No data detected on the port 1000 On Off Good 1000 Mbps Gigabit Ethernet link No 1000 Mbps link; possible link at different speed, possible bad cable, bad connector, or configuration mismatch 100 On Off Good 100 Mbps Fast Ethernet link No 100 Mbps link; possible link at different speed, possible bad cable, bad connector, or configuration mismatch Preparing to Install Your GA622T Copper Gigabit Ethernet Card Follow the instructions provided in this section for installing the GA622T Copper Gigabit Ethernet Card in your server or workstation. For additional information about performing these tasks on your particular system, refer to the manuals included with your system hardware. Before installing your Gigabit Ethernet Card: 1. Make sure that your system meets the hardware and software requirements provided in Table 2-1. 2. Make sure that your system uses the latest BIOS. 3. Turn off the power to your PC. • If you are running Windows, close all applications and click Start from the desktop menu, select Shut Down, and then select Shut down the computer. • If you are running NetWare, use the following commands to shut down the server functions and reach the DOS prompt: server_name: down server_name: exit hardware installation 2-6