Nikon F50D Instruction Manual - Page 28
Using Built-In Flash, Rewind
![]() |
UPC - 074101484687
View all Nikon F50D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
Using Built-In Flash Use the built-in flash not only when the readylight blinks, but also when your subject is in shadow or backlit. See pages 51 to 55. 5 Fully depress the shutter release button to take a picture. The film automatically advances by one frame. - Shutter speed indication without ,,' , "should be read as a reciprocal fraction, i.e., "15" stands for 1/15 second, "15" H for 15 seconds. -In Single Servo AF mode, if a stationary subject moves, remove your finger from the shutter release button, then lightly press it again to restart autofocus. 28 Auto Rewind e When the film reaches the end of the roll, auto rewind begins. During rewinding, and ~ blink e in the LCD panel. After rewind automatically stops, frame counter shows E and blinks for a few seconds. You can then remove film cartridge. • When battery power is very weak, or when the temperature is very low, fIlm may not rewind at the end of roll; Err appears in the LCD panel. In this case, replace battery with a fresh one, or wait for the temperature to rise and then press the rewind button. To rewind film at mid-roll: Press the rewind button at the bottom of the camera.
![](/manual_guide/products/nikon-f50d-instruction-manual-9a56016/28.png)