Oki PM4410 Users' Guide OkiLAN 6100e+ - Page 205
Overview, System Requirements, Before You Start
View all Oki PM4410 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 205 highlights
EtherTalk Section 7 - Chapter 1 - Introduction Chapter 1 Introduction Overview This section describes the steps necessary to configure the EtherTalk protocol. The following topics are covered in this section: • Setting the Printer Name • Selecting a Zone • Selecting the Printer from the Macintosh Chooser • Print Configuration and Status Information • Advanced Configuration System Requirements Please note the following system requirements: • PostScript Level 2 must be available on your printer • The network must be a Phase 2 EtherTalk network • Your printer must have a bidirectional parallel port (IEEE-1284 standard) Ethertalk is only available on the parallel port.. Before You Start 1. Install the OkiLAN 6100e+ hardware and connect the cabling. Instructions for hardware installation are found in Section I of this manual. 2. Write down the serial number and Ethernet address of the OkiLAN 6100e+. 3. Copy the files from the CD-ROM to a utilities folder on the Macintosh hard drive. 4. Consult your network administrator before using the OkiLAN 6100e+ utility. Changing the OkiLAN 6100e+ Name or Zone may require users to reselect the OkiLAN 6100e+ in the Chooser. Print servers and spoolers may also need to be reconfigured after the OkiLAN 6100e+ product's configuration has been changed. OKI OkiLAN 6100e+ User's Guide VII - 3