Oki PM4410 Users' Guide OkiLAN 6100e+ - Page 84

Section 4 - Chapter 1 - Introduction Network Preparation • You should be familiar with network administration as well as the physical setup and operation of your network. • Advise users of possible disruption during installation. • Make sure the serial number and Ethernet address of your OkiLAN 6100e+ are available. • Assign an IP address and a hostname (alias) to the OkiLAN 6100e+. Use the network name service or the "/etc/hosts" file to add the OkiLAN 6100e+ to the network. Before You Start Before running OkiNet for TCP/IP, you must do the following: • Install the OkiLAN 6100e+ hardware and connect the cabling. Instructions for hardware installation are found in Section I of this manual. • Write down the serial number and Ethernet address of your OkiLAN 6100e+. (These numbers are located on the OkiLAN 6100e+ board.) • Install OkiNet for TCP/IP-see Section I. Overview of TCP/IP Configuration • Assign an IP address for the OkiLAN 6100e+ • Configure the OkiLAN 6100e+ network information • Configure hosts for printing to the OkiLAN 6100e+ • Test print (optional) IV - 6 OKI OkiLAN 6100e+ User's Guide