Onkyo HT-S7200 Owner Manual - Page 42
Speaker Settings, Powered Zone 2
![]() |
View all Onkyo HT-S7200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
First Time Setup-Continued Speaker Settings 4 If you change these settings, you must run the Audyssey 2EQ™ Room Correction and Speaker Setup again (see page 45). If you've connected your front speakers to the FRONT L/R and SURR BACK L/R terminal posts for bi-amping, you must change the "Speaker Type" setting. For hookup information, see "Bi-amping the Front Speakers" on page 18. Notes: • When bi-amping is used, the AV receiver is able to drive up to 5.1 speakers in the main room. • Before you change these settings, turn down the 5 volume. 1 Press the [RECEIVER] button, followed by the [SETUP] button. The main menu appears onscreen. If the main menu doesn't appear, make sure the appropriate external input is selected on your TV. 2 Use the Up and Down [R]/[X] but- tons to select "2. Speaker Setup", and then press [ENTER]. The "Speaker Setup" menu appears. 2. Speaker Setup 1. Speaker Settings 2. Speaker Configuration 6 3. Speaker Distance 4. Level Calibration 5. Equalizer Settings Use the Up and Down [R]/[X] buttons to select "Speaker Type", and then use the Left and Right [F]/[S] buttons to select: Normal: Select this if you've con- nected your front speakers normally. Bi-Amp:Select this if you've connected your front speakers for bi-amped operation. Note: Powered Zone 2 cannot be used if "Speaker Type" is set to "Bi-Amp". Use the Up and Down [R]/[X] buttons to select "Surr Back/Front High", and then use the Left and Right [F]/[S] buttons to select: Front High: Select this if you've connected your front high speakers to the SURR BACK L/R terminal posts. Surr Back: Select this if you've connected your surround back speakers to the SURR BACK L/R terminal posts. Note: If the "Speaker Type" setting is set to "Bi-Amp", or "Powered Zone 2" is set to "Not Act", this setting cannot be selected. Press the [SETUP] button. The setup menu closes. 3 Use the Up and Down [R]/[X] but- Powered Zone 2 tons to select "1. Speaker Set- tings", and then press [ENTER]. See "Zone 2" on page 82. The "Speaker Settings" menu appears. Note: This procedure can also be performed on the AV receiver 2-1. Speaker Settings by using its [SETUP] button, arrow buttons, and Speaker Type Powered Zone 2 Surr Back/Front High Normal Not Act Surr Back [ENTER] button. 42
![](/manual_guide/products/onkyo-hts7200-owner-manual-431340c/42.png)