Onkyo TX-NR747 User Manual - Page 91
Connecting and Operating Onkyo RI Components, About RI Function, RI Connection and Setting
View all Onkyo TX-NR747 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 91 highlights
Connecting and Operating Onkyo RI Components RI Connection and Setting Connecting and Operating Onkyo RI Components About RI Function Connecting an Onkyo component with RI jack such as the separately sold RI Dock to the unit by using an RI cable and an analog audio cable enables the following RI functions: System On / Auto Power On: Starting playback on a component connected via RI when the unit is on standby mode, automatically turns on the unit to select the relevant component as its input source. Direct Change: When playback is started on a component connected via RI, the unit selects that component as the input source. Remote Controller Operation: Allows you to operate RI-compatible Onkyo components using the AV receiver's remote controller. Point the remote controller at remote control sensor of the unit. This operation is possible only when the RI remote control code is programmed. ●● Some components may not support all RI functions. ●● These functions do not work when Zone 2 is turned on. ●● For information on the RI functions, also refer to each component's instruction manual. 2. With the number buttons, enter the following 5-digit L remote control code within 30 seconds. R RI Dock: 81993 Cassette tape deck with RI jack: 42157 ●● Programming is complete when the remote indicator flashes twice. The remote indicator flashes once slowly when programming the remote control code fails. Try programming again. Connect an Onkyo component with RI jack to this unit using an RI cable and an analog audio cable. For details, refer to the instruction manual of the component with RI jack. The RI cable can be connected in any order. When there are two RI jacks, both jacks work in the same way and are interchangeable. To connect the RI Dock or cassette tape deck via RI, the following settings are required. Rename the input selector To make the RI functions work, you must rename the input selectors on the unit. Press CD or GAME to display "CD" or "GAME" on the main unit display. Then press and hold CD or GAME 3 seconds or more to switch the display to "DOCK" or "TAPE". To program the RI remote control code Program the remote control code to any REMOTE MODE button on the remote controller. This will allow you to operate the component by pointing the remote controller at the unit instead of the component. 1. Press and hold DISPLAY for 3 or more seconds while holding down the REMOTE MODE button to which you want to program the remote control code. ●● The remote indicator will light. ●● The RECEIVER and ZONE2 buttons cannot be programmed. Input selector on the RI Dock: Switch to "DOCK" or "TAPE". For details, refer to the RI Dock's instruction manual. To operate Onkyo components directly or Onkyo components that are not connected via RI, use the following remote control codes: Onkyo DVD player: 30627 Onkyo CD player: 71817 RI Dock: 82990 ●● With some models, operation may be not possible in part or not possible at all. En-59