Panasonic BTLH80W BTLH80W User Guide - Page 36

Error/Warning Displays If for any reason an error occurs in the unit, the user is alerted of error or warning with the following displays. Error/Warning Inverter error Warning of improper operation status for the camera settings Battery level warning Battery level error Display All the lamps on the side of picture adjusting knobs flash at 1-second intervals. is displayed. The voltage display flashes. "END BATTERY" is displayed for approximately 3 seconds before the power supply switches OFF. Solution Switch the power supply OFF once, then switch it back ON again. If an error is still displayed, contact the vendor where you purchased the unit. Check the setting values of the camera. Replace with a fully charged battery. Replace with a fully charged battery. Maintenance • To clean the cabinet or surface of the liquid crystal protection panel, gently wipe with a soft, dry cloth. If the surfaces are extremely dirty, use a soft cloth dipped in a weak detergent solution and then wrung-out to clean the surfaces, then use a dry cloth to finish. Water or similar substances getting inside the monitor can cause a malfunction. • Never use thinner or benzene to clean this unit. Doing so would cause the surface of the monitor to become discolored, and cause paint to peel. • Do not spray cleansers directly onto the monitor. Water or similar substances getting inside the monitor can cause a malfunction. Specifications GENERAL Power supply: DC 12 V (11.0 V to 17.0 V) Input current: 1.5 A indicates safety information. Dimensions (W × H × D): Weight: Operating temperature: Operating humidity: Storage temperature: 218 mm × 166 mm × 64.7 mm (8-9/16 inches × 6-9/16 inches × 2-9/16 inches) 1.5 kg (3.3 lb) 0 °C to 40 °C (32 °F to 104 °F) 10 % to 85 % (no condensation) -20 °C to +60 °C (-4 °F to +140 °F) Panel Size: Aspect ratio: Number of pixels: Display colors: Angle of view: 7.9-inch V (Effective display area) Panel: 16:9 (Effective display area) Panel: 800 × 450 (Effective display area) Approx. 16.77 million colors Top-bottom direction: 110 ° Left-right direction: 120 ° Input connectors VIDEO: Analog component (YPBPR): SDI: VF: GPI: RS-232C: 1 line, BNC × 1 (Shared with the analog component Y input terminal) 1 line, BNC × 3 (Of these, the Y input terminal is shared with the VIDEO input terminal) 1 line, BNC × 1 (Optional) D-sub, 15 pins × 1 D-sub, 9 pins × 1 D-sub, 9 pins × 1 36