Panasonic BTLH80W BTLH80W User Guide - Page 8

Controls and Their Functions (continued) Rear panel 7 17 89 7 SDI (OPTION) VIDEO/ Y PR PB VF GPI RS-232C DC IN 10 11 12 13 18 16 15 17 14 18 7 REAR TALLY (red) Can be lit by a control signal from a GPI/camera. 8 SDI (HD/SD) input terminal (BNC) - option This is the SDI input terminal. (Compatible with HD/SD automatic switching) • If you want this input, contact the vendor where you purchased the unit. 9 VIDEO/Y input terminal (BNC) This is the VIDEO signal (component signal) input terminal/Y input terminal. 10 PBPR input terminal (BNC) This is the PBPR signal (analog component signal) input terminal. 11 VF terminal (D-SUB, 15 pins) This terminal connects to the VF (viewfinder) terminal of broadcasting and business cameras made by Panasonic. The unit can be used as the viewfinder for such a camera. 12 GPI input terminal (D-SUB, 9 pins) External control is possible by using a GPI signal. 13 RS-232C terminal (D-SUB, 9 pins) External control is possible by using an RS-232C interface. 14 DC IN terminal (XLR, 4 pins) This is the external DC power supply input terminal. When a DC power supply is connected concurrently with the battery, the external power input takes precedence. 15 Light control switch This is not used on this monitor. 16 Battery holder This holder is used with a battery made by Anton/Bauer. 17 Screw holes for tripod fixing There are two screw holes on both the top and bottom for fixing the unit to a tripod (compatible with 3/8-16UNC). In addition, removable screw spacers are installed in one of the screw holes on the bottom of the unit, which are compatible with 1/4-20UNC screws. Use the size that matches the diameter of the tripod's fixing screw. 18 Screw holes for fixing There are four screw holes (M3) for fixing the mounter on the rear of the unit, two each on the left and right. 8