Panasonic CF- Notebook Computer - Page 23

22 Windows 98 Select [Start] - [Settings] - [Control Panel] - [Network] - [TCP/IP PRISM2 IEEE 802.11 PC CARD Adapter] - [Properties] - [IP Address], set the parameters by following the above screen, then select [OK]. Windows 2000 Select [Start] - [Settings] - [Control Panel] - [Network and Dial-up Connections] -[Local Area Connection 2] - [Properties] -[Internet Protocol (TCP/IP)] [Properties], set the parameters by following the above screen, then select [OK]. 23 Restart the computer. Getting Started NOTE Windows 98 Be sure to prepare the following. • Optional port replicator (CF-VEB071) • External keyboard • External display When using the files in the following folders available on the retail version of the Win- dows CD-ROM, it is necessary to run a separate file decompression program. \tsclient \tools To uncompress the file, it is necessary to have approximately 80 MB of free disk space available on the hard disk. To use the CD-ROM drive in MS-DOS mode, perform the operation below after modi- fying config.sys and autoexec.bat ( "CD-ROM Drive"). File decompression method: 1 Turn on your computer. 2 When [Press to enter SETUP] is displayed, immediately press Ctrl (until the menu is displayed). 3 Select [Command prompt only]. 4 Insert the Product Recovery CD-ROM. 5 At the prompt, input the following: L:\en\addfile Enter Follow the message on the screen. After this program is executed, the contents of the above folders will be decompressed to the c:\util\win98add folder. Windows 2000 When a new device has been installed or a new Windows Component has been added in [Start] - [Settings] - [Control Panel] - [Add/Remove Programs], [Insert Disk] may appear. Select [OK] and specify [c:\winnt\cdimage] in place of [c:\sysprep\i386] or [D:], then select [OK]. e.g. [c:\winnt\cdimage\i386] in place of [D:\i386] 23