Panasonic CF- Notebook Computer - Page 33

Starting Up When the previous item is not the cause Press F9 in the Setup Utility ( "Setup Util- ity"). This will restore the Setup Utility's settings to their default values (except the password settings). Try removing all peripheral devices. Windows 98 Run SCANDISK to check the hard disk. At start-up, press Ctrl to operate the computer in the Safe mode. Windows 2000 Click [Local Disk(C:)] in [My Computer] with the right button, select [Properties], then select [Tools] - [Check Now]. At start-up, press F8 to operate the computer in the Safe mode. The cursor cannot be controlled Restart the computer by using the keyboard (e.g., or Ctrl + Esc ). When the port replicator is not connected, turn off the com- puter. The password is not required when resuming from the standby or hibernation mode Use the Windows password as the following. Select [Start] - [Settings] - [Control Panel] - [Power Management]* - [Advanced], then add the check mark for [Prompt for password when computer goes off standby]. * Windows 2000 : [Power Options] Press the Menu button of the wireless display, then set the password ( Operating Instructions of the wireless display). The DISPLAY READY indicator does not go on even when the HDD indicator goes off A problem possibly occurred during startup. After powering off the computer, connect the port replicator and restart the computer. Windows 98 When starting up in the MS-DOS mode, the USB floppy disk drive can not be used After powering off the computer, connect the USB floppy disk drive and restart the computer. Windows 2000 The password of the administrator was forgotten After reinstalling, setup Windows, then set the password again. 33 Troubleshooting