Panasonic DMREZ475V Dvd Recorder - English/spanish - Page 80

Troubleshooting Guide General Issues Operation Page Cannot operate the TV or Set Top Box with the unit's remote control. Change the manufacturer code on the remote control. Select TV or Set Top Box mode on the remote control. Cannot operate the DVD. Press [DRIVE SELECT] to select the DVD drive when operating DVDs or CDs. -Make sure the TV is on the correct channel or input mode. Cannot operate the VHS. Press [DRIVE SELECT] to select the VHS drive when operating VHS cassettes. -Make sure the TV is on the correct channel or input mode. The remote control doesn't work. The remote control code is wrong. Change to the correct code. The batteries are depleted. Replace them with new ones. Point the remote control at the remote control sensor on the main unit. Remove obstacles between the remote control and main unit. Remove dust from the transmission window and the unit's sensor. Colored glass may obstruct the signal reception/transmission. Don't place the signal sensor in direct sunlight or in areas that may be subject to sun exposure. It may be necessary to set the code on the remote control again after changing the batteries. It may be necessary to set the manufacturer code again after changing the batteries. The unit is on but cannot be operated. Some operations are prohibited by the disc. The unit is warm ("U59" appears on the unit's display). Wait until "U59" disappears. One of the unit's safety devices may have been activated. Reset the unit as follows: Press [/I POWER] on the main unit to switch to off. If the unit doesn't switch to off, reset the unit (¼ 78, "To restore the unit if it freezes"). "U88" is displayed and the disc cannot be ejected. The unit is carrying out the recovery process. Do the following to eject the disc: (1) Press [/I POWER] on the main unit to switch to off. If the unit doesn't switch to off, reset the unit (¼ 78, "To restore the unit if it freezes"). (2) While the unit is off, press and hold [] and [CH ] on the main unit at the same time for about 5 seconds. (Ejection may take extra time depending on discs.) The disc may be defective. Try another disc. Cannot eject a disc. The unit is recording. The unit may have a problem. Eject the disc as in (2) above. Startup is slow. Startup takes time in the following situations: -A disc other than a DVD-RAM is inserted. -The clock is not set. -Immediately after a power failure or the AC power supply cord is connected. -When the unit is connected with an HDMI cable. A password screen appears and If the unit starts receiving a broadcast with the set rating information, you are unable to view or record. a password screen appears and you will be unable to view or record. Enter your password to continue. Time is incorrect after using Auto Clock Setting. Try again. If the time is still incorrect, set the clock manually. 68 68 7 7 78 5 5 78 68 − − − − − − − 52 48, 66 80 RQT8853