Panasonic PTAE8000 Operating Instructions - Page 63
[WSS], [OVER SCAN], [KEYSTONE], [AUTO SETUP], Switch settings, Shrink image, Enlarge image, Image
View all Panasonic PTAE8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
[POSITION] menu [WSS] In the European broadcasting system, if the input signal contains an identification signal, WSS automatically switches the aspect ratio to the required setting. ( page 61) Switch settings Switch settings [ON] [OFF] Switch automatically Do not switch automatically Note zzAspect ratio switches only in the case of these input signals: PAL/625i (576i)/625p (576p) [OVER SCAN] If the 4 edges of an image are partly dropped, you can use this function to adjust and project it properly. Shrink image Enlarge image zzSetting range: 0 to +10 Note zzCOMPUTER signal (exc. movie based signals) is not supported. [KEYSTONE] If the projector is aligned non-perpendicularly to the screen, or if the projection screen has an angled surface, you can correct the keystone vertically. Image Operation Note zzYou can correct the distortion ± 30 degrees from the vertical plane. However, if there is overcorrection, the image quality may deteriorate and become blurry. For a better quality image, installing the projector with minimum distortion is recommended. zzWhen adjustment with [KEYSTONE] carried out, the vertical center of the screen and the lens need to be realigned. zzThe result of the keystone correction will affect the size of the image. zzKeystone correction does not function on the menu screen. zzSome distortion may occur due to lens shift adjustment. zzThe result of the keystone correction may affect the aspect ratio. zzWhen adjustment is performed with keystone correction, the parallax adjustment result set in the [3D VIEWING MONITOR] is discarded, and the parallax adjustment function is disabled. [AUTO SETUP] COMPUTER IN (RGB) signals only (exc. movie based signals) When you select [AUTO SETUP] and then press the button, [H-POSITION], [V-POSITION], [DOT CLOCK], and [CLOCK PHASE] are adjusted automatically in accordance with the input signal. Settings zzSetting range: −32 to +32 ENGLISH - 63