Panasonic SAXR58 SAXR58 User Guide - Page 17
To turn on SPEAKERS A., Speaker output and level, Automatic speaker detection
![]() |
View all Panasonic SAXR58 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
↓ ↓ ↓ Before playback ENGLISH Automatic speaker detection Automatic speaker detection is performed during auto speaker setup. Do the following only if you want to check speakers' status, and not other settings. 1 Turn on the unit. Press • The standby indicator goes off when you turn on the unit. 2 Start automatic speaker detection. SPEAKERS A B Press at the same time. AUTO DETECTOR (Checks each speaker's connection status) (Shows the number of detected speakers, excluding the subwoofer) (Shows connected speakers) (Automatic speaker detection ends. The previous display reappears) • These settings are saved even if you turn the unit off. • Refer to page 14 for further notes and page 16 for error message explanations. ("WARNING" may appears on the display during the detection here.) Speaker output and level Adjust the level of the speakers so they are the same apparent level as the front speakers from the seating area. Speaker level is adjusted during auto speaker setup. Do the following only if you find the level unsatisfactory. 1 To turn on SPEAKERS A. SPEAKERS A Press If you have bi-wired your front speakers (➡ page 13), make sure you have selected "YES" for the "LR BI-WIRE setting" (➡ page 27). SPEAKERS SPEAKERS A B Press or SPEAKERS BI-WIRE AB SPEAKERS A are on SPEAKERS A and B are on SPEAKERS or A SPEAKERS AB • The unit does not output the test signal if only SPEAKERS B is on. 2 AUTO Press TEST to output the test signal. • The signal is output from each speaker in order for about two seconds each: L→C→R→RS→SBR→SBL→LS→SUBW or L→C→R→RS→SB1→LS→SUBW 1If you connect one surround back speaker only (the left surround back speaker) Speaker abbreviations L: Front left R: Front right LS: Surround left SBL: Surround back left SUBW: Subwoofer C: Center RS: Surround right SBR: Surround back right SB: Surround back (If you connect one surround back speaker) Make sure your speaker settings match your connections (➡ pages 13, and 14 to 16). There will be no output from a speaker if it is set as NO or NONE (➡ page 27). 3 Set speakers volume to the level you would normally use. Press VOLUME Volume range: -- dB (minimum), -79 dB to 0 dB (maximum) 4 LEVEL Press to select the speaker channel to adjust. 5 Press to adjust the level to the same apparent level as the front speakers. Repeat steps 4 and 5 for each speaker channel. Adjustment range: -20 dB to +10 dB (Factory setting: 0 dB ) For the subwoofer (SUBW) MIN (minimum) ↔ 1 to 29 ↔ MAX (maximum) (Factory setting: 20 ) The test signal is output only from the speaker you are adjusting in steps 4 and 5. Test signal for connected speakers resumes after 2 seconds. 6 AUTO Press TEST to stop the test signal. 17 RQTV0156
![](/manual_guide/products/panasonic-saxr58-saxr58-user-guide-8972388/17.png)