Panasonic TH-50PX600 Operating Instructions - Page 23

Using Timer •The TV can automatically turn On/Off at the designated date and time. The Clock must be set before On time/Off time settings. (p. 13) 1 Display menu 2 Select "Timer" Menu Picture Audio Timer Lock TMVeGm/oPrhyoctoard Setup next select - ■Press to exit ■Press to return to the previous screen Note •The TV automatically turns Off after 90 minutes when turned On by the Timer. This operation will be cancelled if the Off time is selected or if a key is pressed. 44 3 Select the timer to set select Timer Sleep next Timer 1 Timer 2 Sleep Turns Off automatically Timer 3 Timer 4 Timer 5 ~ Timer 1 Timer 5 Turns On/Off automatically (5 timers can be set.) 4 Set the timer ■To set "Sleep" (Off Timer) Press to set unit to shut itself off after a preselected amount of time. Sleep •0/30/60/90 (minutes) Sleep 60 select ■To set "Timer 1-5" (On/Off Timer) Select the item and set Timer 1 CH Day On time Off time Set 310 - 1 EVR FRI 10:00 AM 11:00 AM On select set CH Select the channel Day Select the day SUN/MON/TUE/WED/THU/FRI/SAT/ MON-FRI/SAT-SUN/DAILY/EVR SUN/ EVR MON/EVR TUE/EVR WED/EVR THU/ EVR FRI/ EVR SAT On time The time to turn On Off time The time to turn Off Set Timer setting (On/Off) Operating Peripheral Equipment You can operate other manufacturers' components using this TV's remote control. 1 Connect the external devices to the TV and turn Off the external equipment 2 + Press both buttons simultaneously for more than 3 seconds. •Release the buttons when the equipment selection buttons start flashing. 3 Select the equipment with the equipment selection button •The selected button remains lit (other buttons are not lit). Input the equipment's 4-digit remote 4 control code (p. 49-50) 5 Confirm the equipment with the remote control •The external equipment turns On. ■If the equipment does not operate with •remote control When your equipment has a single code • Input the remote control code again When your equipment has multiple codes Change the code with above and test again (p. 49-50) Caution •Registration will fail if the wrong code is input or it takes more than 30 seconds to register. To find a code not listed in the code list This procedure searches all codes and is called the "sequence method." After step above, change the code and test When the correct code is found store change Operate the equipment with the remote control (p. 48) •• Repeat until the code is found It may take many attempts before the correct code is found 45 Operating Peripheral Equipment Using Timer Advanced