Panasonic VDRM30 VDRM30 User Guide - Page 45

Removing Disc 1 Set the power switch to "POWER OFF" to turn the DVD Palmcorder off. 2 Press down the DISC EJECT button once and release it. In a moment, the cover of disc insertion block will open slightly. DISC EJECT 3 Gently open the cover until it stops. Note: • It is recommended that you turn the DVD Palmcorder off when inserting or removing disc, in order to prevent faulty operation. • Even after the DVD Palmcorder is turned on, the disc can be removed unless it is in recording status. Hold down the DISC EJECT button for approximately 2 seconds, and then release it to remove the disc. (The DISC EJECT indicator on the LCD screen will blink.) It is recommended that you turn the DVD Palmcorder off before inserting or removing disc to prevent misoperation. • Do not detach the battery pack or AC adapter/charger until the DVD Palmcorder is completely turned off. • Do not insert anything other than the 8 cm DVD-RAM or DVD-R disc into the disc insertion block: Doing so could cause malfunctions. • Set the power switch to "POWER OFF" to turn the DVD Palmcorder off. • When inserting or removing the disc, be careful not to touch the inside of DVD Palmcorder (especially, the lens of laser pickup). • When inserting or removing the disc, connect a charged battery pack or AC adapter/charger to the DVD Palmcorder: The disc cover will not open unless the DVD Palmcorder is powered. When the cover is fully open, the disc will slightly come out from the disc guide, and stop. 4 Remove the disc. Hold disc Hold the top around this of Round portion. DVD Holder as shown in the illustration and gently pull it out. Note: • Be careful not to touch the disc exposed portion when removing the disc. 5 Gently push the section indicated "PUSH CLOSE" on the cover of disc insertion block (on side), to close the cover. 45