Panasonic WJRT416V WJRT416V User Guide - Page 57

w Configure the manual recording settings [Manual Rec. Setup] Configure the settings for manual recording that starts recording when the [REC] button is pressed. Manual Rec. Setup Camera No. 01 Rec. Quality SP Fine Rec. Frame Rate Full All OK Cancel Camera No. Select a camera channel to be used for manual recording. Note: The camera selection buttons (1 - 10/0) are available for the camera channel selection. Rec. Quality Select an image quality for recorded images from the following. SP Fine: Highest quality Fine: High quality Normal: Standard quality Extended: Low quality Default: SP Fine Rec. Frame Rate Select a recording frame rate from the following. Full, 1/2F, 1/4F, 1/8F, 1/16F (When "Full" is selected, recording frame rate will be 30 frames/sec for NTSC model and 25 frames/sec for PAL model.) Default: Full Note: When the [SET] button is pressed after moving the cursor onto "All", the same settings for "Rec. Quality" and "Rec. Frame Rate" will be applied to all of the camera channels. e Configure the timer recording settings [Timer Rec. Setup] Designate a day of the week and time when the timer recording is to be started (timer recording schedule). Camera No. Timer Rec. Setup 01 SP Fine Full SUN 00: 00 MON 00: 00 TUE 00: 00 WED 00: 00 THU 00: 00 FRI 00: 00 SAT 00: 00 DAILY 00: 00 All 24: 00 24: 00 24: 00 24: 00 24: 00 24: 00 24: 00 24: 00 Off Off Off Off Off Off Off Off OK 00: 00 00: 00 00: 00 00: 00 00: 00 00: 00 00: 00 00: 00 24: 00 Off 24: 00 Off 24: 00 Off 24: 00 Off 24: 00 Off 24: 00 Off 24: 00 Off 24: 00 Off Cancel Camera No., Rec. Quality, Rec. Frame Rate These settings can be configured in the same manner as for "Manual Rec. Setup". Refer to the "Manual Rec. Setup" section. Recording time range Set the start time and end time for the desired day of the week, and then select "On". Up to 2 time ranges can be set as the timer recording schedule. To set the same time range for every day of the week, enter the start and end time for "DAILY". When "On" and "Off" of 2 different schedules are set in the same time range, the timer recording will be carried out according to the schedule for which "On" is selected. Note: When the [SET] button is pressed after moving the cursor onto "All", the same settings for "Rec. Quality", "Rec. Frame Rate" and "Recording time range" will be applied to all of the camera channels. 57