Panasonic WVNW474S WVNW474S User Guide - Page 34
APPENDIX, Optional Heater Unit WV-CW3H
View all Panasonic WVNW474S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
APPENDIX ■ Optional Heater Unit WV-CW3H ● Introduction Installing this heater unit enables the camera to operate under in a low-temperature environment of -30°C (-22°F). The heater turns on automatically when the temperature inside the camera drops below +10°C (50°F) and turns off when it rises. A small fan inside the unit will minimize condensation on the surface of the dome cover caused by changes in ambient temperature unless temperatures change too rapidly. The fan will stop when there is no possibility of condensation. ● Precautions • This product should be installed and connected by qualified service personnel or system installers. • Do not use the same 24 V AC power source supplying the power to the camera for the heater unit. Connect anoth- er 24 V AC power source to the heater unit. If the same power source is used, turning the heater on and off may disturb the camera images. • When servicing, pay attention to high temperature on the surface of the unit. Disconnect the harness and wait until it cools. • When you install the camera in a low-temperature location and start operating it, it may take time (around 30 minutes) for the inside of the camera to warm up. Cut power once then supply power again. ● Installation 1. Open the dome cover. (See Disassembling the camera.) 2. Place the heater unit in the camera and fix it with the sup- plied screw. 3. Insert the harness into the heater unit connector of the camera. 4. Fold the desiccant pack in half, and attach it with adhe- sive tape to point "A" shown in the figure. Note: Attach the desiccant pack so that it does not block ventilation holes or hang over the top of the wall. 5. Attach the dome cover while paying attention not to pinch the harness cable. 6. Connect the heater power cable of the camera. (See Connection.) Adhesive tape Fold Point "A" (wall) Supplied screw Harness ● Specifications Required power: Power consumption: Dimensions: Weights: 24 V AC, 60 Hz 12.1 W maximum 29 mm (H) x 83 mm (W) x 89.5 mm (D) [1-1/8" (H) x 3-1/4" (W) x 3-1/2" (D)] 45 g (0.1 lbs) ● Accessories Fixing screw (M3 x 12 1 pc. Desiccant pack 1.pc. -34-