Pioneer AXM-P8000 Owner's Manual - Page 26
Using the down-mix function, Setting the speaker setting, Digital Signal Processor - dimensions
UPC - 012562693538
View all Pioneer AXM-P8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Section 07 Digital Signal Processor Adjusting the Music mode You can adjust the Music mode with the following three controls. ! Panorama (Panorama) extends the front stereo image to include the surround speakers for an exciting wraparound effect. ! Dimension (Dimension) allows you to gradually adjust the sound field either towards the front or the rear. ! Center Width Control (Center W Control) allows center-channel sounds to be positioned between the center speaker and the left/right speakers. It improves the left-center-right stage presentation for both the driver and the front passenger. 1 Press p until MUSIC appears in the display. 2 Press n to select Panorama. 3 Press q or r to turn Panorama on/ off. 4 Press n again to select Dimension. 5 Press q or r to select your favorite setting. Each time you press q or r it moves the sound towards the front or the surrounds. 3 3 is displayed as the front/surround speaker balance moves from front to surrounds. 6 Press n again to select Center W Control. 7 Press q or r to select your favorite setting. Each time you press q or r it gradually spreads the center channel sound into the front left and right speakers over a range 07. 3 is the default and its recommended for most recordings. 0 places all center sound in the center speaker. 7 places all center sound equally in the left/right speakers. Using the down-mix function The down-mix function allows you to play back multi-channel audio in 2 channels. 1 Press r to select Downmix. Press r until Downmix appears in the display. 2 Press o or p to switch the down mix settings. ! Lt/Rt Down mix so that the surround components can be restored (decoded). ! Lo/Ro Stereo mix the original audio that do not contain channel modes such as surround components. Setting the speaker setting You need to make with/without (or yes/no) and size (bass reproducing capacity) selection/adjustments depending on the installed speakers. The size needs to be set to LARGE (large) if the speaker is capable of reproducing sounds of about 100 Hz or below. Otherwise select SMALL (small). ! Low frequency range is not output if the subwoofer is set to OFF and the front and rear speakers set to SMALL or OFF. ! It is imperative that non-installed speakers be set to OFF. ! Set the front or rear speaker to LARGE if the speaker is capable of reproducing bass content, or if no subwoofer is installed. 26 En