Pioneer DVR-650H-S Operating Instructions - Page 119
Initial Setup > Audio Out >
UPC - 012562853048
View all Pioneer DVR-650H-S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 119 highlights
Additional information 15 Problem All settings are reset Remedy • If the recorder is unplugged (or there is a power failure) while the recorder is on, all the settings will be lost. • Make sure that you switch the recorder into standby before unplugging the power cord. Remote control does not work • If you connected this recorder to another Pioneer product using the CONTROL IN jack, point the remote control at the other component to use (page 14). • Set the remote control to the same ID number as the recorder (page 114). (When the batteries run down, the remote mode is automatically reset to Recorder1.) • Use the remote within its operating range (page 6). • Replace the batteries (page 6). No sound or sound is distorted • Make sure that the amp/receiver or TV is set to the correct input and the volume turned up. • There is no sound when the picture is paused, or during scanning or slow motion play. Press PLAY to resume regular playback. • DTS discs can only be played if this recorder is connected to a DTS decoder or DTS compatible amp/receiver. If you have connected a suitable decoder, also make sure that the Initial Setup > Audio Out > DTS Out setting is On. • Some 96 kHz discs do not output audio through the digital jack. In this case, switch the input of your amp/receiver to analog. • Check the audio cable connections (page 14). • If the sound is distorted, try cleaning the cable plugs. Cannot switch a dual • During real-time copying it is not possible to switch audio channels. mono programme The main and sub channels are both output. The picture is distorted • Change the Input Line System setting (page 114). (You can also change it by pressing the (Stop) button and INPUT SELECT on the front panel simultaneously with the recorder stopped.) The picture from the external input is distorted • If the video signal from the external component is copy-protected, you cannot connect via this recorder. Connect the component directly to your TV. Screen is stretched vertically or horizontally • Make sure that the TV Screen Size setting (page 111) is correct for the kind of TV you have (see also page 129). • If you have a widescreen TV, check its aspect ratio settings. • This recorder's input switches into wide mode automatically according to the input signal. When the unit connected is not compatible with VIDEO ID-1 (widescreen signalling), set the connected component to output 4:3 aspect ratio (standard) video. 119 En