Pioneer VSX-14 Owner's Manual - Page 38

06 Setting up the receiver When S is selected in the speaker setting, the surround distance cannot be set. Dynamic range control setting • Default setting: OFF Dynamic range is the difference between the loudest and softest sounds in any given signal. With this setting, you can compress the dynamic range, so that low level sounds can be heard more easily (sounding relatively louder) yet louder sounds won't be too overbearing. • Press ' or ' to set the dynamic range control (OFF, MAX, or MID). • When listening at low volumes, set to MAX for maximum dynamic range compression. • Dynamic range control is effective only when a Dolby Digital signal is being played back. Dual mono setting • Default setting: ch1 The dual mono setting can only be used when listening to Dolby Digital discs with dual mono encoding. These discs are not widely used, but are sometimes used when it is necessary to have one language on one channel and a different language on the other. With this setting you can choose which channel in the dual mono setting you want to listen to. If Dolby Digital mode is switched on, you will hear the channel you have selected (either ch1 or ch2) through your center speaker. With Dolby Digital mode off, or if you don't have a center speaker, you will hear the channel you have selected through both front speakers. In the L ch 1. R ch 2 setting, the left front speaker will play channel 1 and the right front speaker will play channel 2. • Use ' or ' to cycle through the possible DUAL MONO settings. L ch 1.R ch 2 ch2 ch1 Coaxial digital input setting • Default setting: DVD Here you tell the receiver what component you have hooked up to the coaxial digital input jack. • Use ' or ' to select the coaxial digital input (DVD, TV, CD, CD-R, VCR or OFF). After you assign a component to the digital jack, whenever you select that component, for example a DVD player, the receiver automatically changes to the digital input setting and DIGITAL shows in the display. Optical digital input setting • Default setting: TV Here you tell the receiver what component you have hooked up to the optical input jack. • Use ' or ' to select the optical digital input (DVD, TV, CD, CD-R, VCR, or OFF). After you assign a component to the digital jack, whenever you select that component, for example a DVD player, the receiver automatically changes to the digital input setting and DIGITAL shows in the display. 38 En