Pioneer VSX-43TX Owner's Manual - Page 25
Speaker impedance, Bi-wiring your speakers - reset
View all Pioneer VSX-43TX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
PREPARATION PREPARATION Connecting Your Equipment Speaker impedance You can change the speaker impedance for VSX-43TX but we recommend using speakers with an impedance of 8 Ω-16 Ω (the default setting). If you are using 6 Ω- less than 8 Ω impedance speakers, you need to change the impedance setting. Use any speaker rated between 6 Ω-16 Ω. STANDBY/ON SPEAKERS STANDBY/ON MOVIE MUSIC ENTER MULTI JOG STANDBY AUDIO/V MULTI JOG CONTROL SET UP RETURN SIGNAL SELECT FL DIMMER SB CH MODE MIDNIGHT LOUDNESS BAND CLASS STATION TUNING SELECT PHONES SPEAKERS TONE TONE CONTROL BASS/TREBLE TUNER EDIT MULTI JOG/ENTER S-VIDEO VIDEO L AUDIO R VIDEO INPUT First put the receiver in STANDBY mode, then press the power button while holding down the SPEAKERS button. The receiver will reset to the new impedance setting. With this method you can choose the 8 Ω16 Ω setting or the 6 Ω-8 Ω setting. To check which impedance setting to hold down the SPEAKERS button for 2-3 seconds. You'll get a display like these telling you the speaker impedance setting. SIGNAL PRO LOGIC Neo :6 AUTO DIGITAL RF DTS ES EX DIGITAL MPEG AAC ANALOG STEREO SB CH AUTO ON OFF DSP MOVIE MUSIC L C R LFE LS S RS SP A B LOUDNESS MIDNIGHT TONE DNR ATT STEREO MONO TUNED RF ATT RDS EON Hi-BIT/ SAMPLING MULTI-ROOM dB (This display indicates an 8Ω-16Ω impedance setting.) SIGNAL PRO LOGIC Neo :6 AUTO DIGITAL RF DTS ES EX DIGITAL MPEG AAC ANALOG STEREO SB CH AUTO ON OFF DSP MOVIE MUSIC L C R LFE LS S RS SP A B LOUDNESS MIDNIGHT TONE DNR ATT STEREO MONO TUNED RF ATT RDS EON Hi-BIT/ SAMPLING MULTI-ROOM dB (This display indicates a 6Ωless than 8Ω impedance setting.) Bi-wiring your speakers This high quality but difficult method of wiring speakers will be unnecessary for most users. In order to do this your speakers must be bi-wireable (that is they must have separate terminals for the high and low frequencies). To bi-wire a speaker, connect two sets of speaker cords to each speaker terminal on the receiver. The easiest way to do this is to connect one wire in the normal way, and use a banana plug for the other one. Make sure you use a parallel (not series) connection when doing so. Don't connect different speakers from the same terminal in this way. 25