Pioneer VSX-43TX Owner's Manual - Page 80

Fine Tuning Your System CROSSOVER NETWORK Crossover frequency is the point where the receiver divides the high and low sounds (the frequencies) between the speakers. Certain bass sounds will play back from the subwoofer if you selected it as YES (or PLUS) or from the front speakers if you selected them as LARGE. This setting decides where the cutoff will be between those bass sounds playing back from the speaker selected as above and the bass sounds for the entire soundtrack, which play back from all speakers used. If all speakers are set to LARGE (see pages 37-38) this setup is unnecessary. RECEIVER MULTI SYSTEM SOURCE OPERATION OFF DVD/LD MULTI CONTROL TV / SAT VCR/DVR TV CONT VCR 2 CD TUNER MOVIE MUSIC ACOUSTIC EQ RECEIVER INPUT SURROUND MODE SB CH MULTI CH MODE INPUT STEREO/ DIRECT ENTER MIDNIGHT MUTE MASTER VOLUME MENU TUNER EDIT TOP MENU SYSTEM SETUP ST TUNE GUIDE ST ENTER AUDIO TUNE RETURN − + CHANNEL DTV ON/OFF BAND CHANNEL D.ACCESS MPX CLASS 1-3 1-3 STANDBY/ON MOVIE MUSIC ENTER MULTI JOG STANDBY MULTI JOG CONTROL SET UP RETURN SIGNAL HI-BIT SELECT HI-SAMPLING SB CH MODE MIDNIGHT LOUDNESS BAND PHONES SPEAKERS TONE TONE CONTROL BASS/TREBLE 2 Use the 5∞ buttons to select frequency cut off point. Press ENTER. 50 Hz: Sends bass frequencies below 50 Hz to the subwoofer (or large speakers). SIGNAL PRO LOGIC Neo :6 LOUDNESS AUTO DIGITAL MIDNIGHT TONE DNR ATT STEREO MONO TUNED RF ATT dB RF DTS ES EX RDS EON DIGITAL MPEG AAC ANALOG STEREO SB CH AUTO ON OFF DSP MOVIE MUSIC Hi-BIT/ SAMPLING MULTI-ROOM L C R LFE LS S RS SP A B 80 Hz: Sends bass frequencies below 80 Hz to the subwoofer (or large speakers). SIGNAL PRO LOGIC Neo :6 LOUDNESS AUTO DIGITAL MIDNIGHT TONE DNR ATT STEREO MONO TUNED RF ATT dB RF DTS ES EX RDS EON DIGITAL MPEG AAC ANALOG STEREO SB CH AUTO ON OFF DSP MOVIE MUSIC Hi-BIT/ SAMPLING MULTI-ROOM L C R LFE LS S RS SP A B 100 Hz: Sends bass frequencies below 100 Hz to the subwoofer (or large speakers). SIGNAL PRO LOGIC Neo :6 LOUDNESS AUTO DIGITAL MIDNIGHT TONE DNR ATT STEREO MONO TUNED RF ATT dB RF DTS ES EX RDS EON DIGITAL MPEG AAC ANALOG STEREO SB CH AUTO ON OFF DSP MOVIE MUSIC Hi-BIT/ SAMPLING MULTI-ROOM L C R LFE LS S RS SP A B 150 Hz: Sends bass frequencies below 150 Hz to the subwoofer (or large speakers). SIGNAL PRO LOGIC Neo :6 LOUDNESS AUTO DIGITAL MIDNIGHT TONE DNR ATT STEREO MONO TUNED RF ATT dB RF DTS ES EX RDS EON DIGITAL MPEG AAC ANALOG STEREO SB CH DSP Hi-BIT/ SAMPLING MULTI-ROOM AUTO ON OFF MOVIE MUSIC L C R LFE LS S RS SP A B 200 Hz: Sends bass frequencies below 200 Hz to the subwoofer (or large speakers). SIGNAL PRO LOGIC Neo :6 LOUDNESS AUTO DIGITAL MIDNIGHT TONE DNR ATT STEREO MONO TUNED RF ATT dB RF DTS ES EX RDS EON DIGITAL MPEG AAC ANALOG STEREO SB CH DSP Hi-BIT/ SAMPLING MULTI-ROOM AUTO ON OFF MOVIE MUSIC L C R LFE LS S RS SP A B Follow steps 1-5 on page 79, if necessary, to get to the starting point mentioned here. 1 CROSSOVER should be selected, if it isn't use the 5∞ buttons to select it. Press ENTER. SIGNAL PRO LOGIC Neo :6 LOUDNESS AUTO DIGITAL MIDNIGHT TONE DNR ATT STEREO MONO TUNED RF ATT dB RF DTS ES EX RDS EON DIGITAL MPEG AAC ANALOG STEREO SB CH DSP Hi-BIT/ SAMPLING MULTI-ROOM AUTO ON OFF MOVIE MUSIC L C R LFE LS S RS SP A B 3 EXIT should be selected (if it's not use the 5∞ buttons to select it). Press ENTER. Next, proceed to FINE CHANNEL LEVEL. If you want to change a setting before proceeding start over from step 1. memo The default is 80Hz. 80