Pioneer VSX-43TX Owner's Manual - Page 99
If the unit does not operate normally due to external effects such as static electricity
![]() |
View all Pioneer VSX-43TX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 99 highlights
Techno Tidbits & Problem-solving Symptom During playback of a DVD audio source, the player shows a transfer rate of 96kHz, but the receiver does not. During playback of a 96kHz source, the display doesn't show 96kHz Cause • The multichannel connections are analog, so there is no digital transfer. Remedy • This is not a malfunction. See the player's manual for more details. • The receiver may be on a different mode than STEREO. • One of the DIGITAL NR, MIDNIGHT, LOUDNESS, or TONE features is switched on. • Switch to STEREO mode (see page 43). • Turn it/them off (see page 47-49). Remote control Cannot be remote controlled. Other components can't be operated with the system remote. The SR cable is connected, but the connected components can't be operated with the remote. • The remote control batteries have worn out. • Too far away or improper angle of operation. • There is an obstacle between the receiver and the remote control. • Strong light such as fluorescent light is shining onto the unit's remote control signal light-receiving window. • A cord is connected to the CONTROL IN terminal on this unit. • The IR Receiver type is mismatched with the setting. • Replace the batteries (see page 7). • Operate within 25 feet and a 30° angle of the remote sensor on the front panel (see page 8). • Remove the obstacle or operate from another position (see page 8). • Avoid exposing the remote sensor on the front panel to direct light. • Connect cord to the correct jack. • Disconnect the IR Receiver from the rear panel, and set to the other IR Receiver type using the remote control. • The preset code settings are wrong. • The batteries wore out and the system settings were cleared. • Input the correct preset code. • Reset the proper system settings. • The SR cable hasn't been connected properly. • The rest of the component connection have not been made. • The component you have hooked up is not SR compatible. • Reinsert the SR cable, making sure it is the right jack (see page 71). • Make sure an analog connection has been made between the units. • This is not a malfunction. If the unit does not operate normally due to external effects such as static electricity Disconnect the power plug from the outlet and insert again to return to normal operating conditions. EXPERT 99
![](/manual_guide/products/pioneer-vsx43tx-owners-manual-d621145/99.png)