Pioneer VSX-43TX Owner's Manual - Page 59

Remote Control of Other Components Setting Up the Remote Control to Control Other Components In addition to controlling the receiver, the supplied remote control can operate your other components (VCR, TV, DVD, CD, etc.) after you program it to do so. In this way, instead of fumbling with many different controls and buttons, you only need to use one remote control. If your component(s) are listed in the remote control's memory, simply follow the steps below. If your component(s) are not listed, or if you want the remote to learn additional operations, you can use the learning mode to input the information from the remote controls supplied with your other components. Recalling Settings Stored in the Remote Control The following steps show you how to recall the setting stored in the remote control. Once a setting is recalled and the component assigned, you can use this remote to easily operate the component. memo • To exit from the remote control setup mode at any time, press REMOTE SETUP. • See "Using Remote Control with Other Components" on pages 61-62 to operate your other components. • The TUNER button cannot be assigned. 2 3 RECEIVER MULTI SYSTEM SOURCE OPERATION OFF DVD/LD MULTI CONTROL TV / SAT VCR/DVR TV CONT VCR 2 CD TUNER MOVIE MUSIC ACOUSTIC EQ RECEIVER INPUT SURROUND MODE SB CH MULTI CH MODE INPUT STEREO/ DIRECT ENTER MIDNIGHT MUTE MASTER VOLUME MENU TUNER EDIT TOP MENU SYSTEM SETUP ST TUNE GUIDE ST ENTER AUDIO TUNE RETURN − + CHANNEL DTV ON/OFF BAND CHANNEL D.ACCESS MPX CLASS DIMMER LOUDNESS TONE EFFECT/CH SEL ENTER SIGNAL SEL DNR BASS/TREBLE DISC VIDEO SEL HI-BIT +− +10 TV CONTROL SUB TITLE INPUT SELECT CHANNEL VOLUME REMOTE SETUP LED 1 1 RECEIVER 1 While holding down the REMOTE SETUP button press to select the preset recall setup mode. The LED begins to blink. To cancel the preset recall setup mode press REMOTE SETUP. 2 Press the MULTI CONTROL button for the component you want to control. The LED lights continously. 3 Point the remote toward the component to be controlled, enter the 4 digit setup code (see pages 9394 for codes). The LED blinks. After a code has been input the power of the component being input will turn on or off. The remote will return to the previous mode after thirty seconds of inactivity. The power of the component being input will only turn on or off if that component is able to be turned on directly by remote control. Repeat steps 2 through 3 to assign preset codes for as many components as necessary. If you can't get your component to respond to any of the codes you can still program the component into the remote control using the procedure in the next section. 4 Press the REMOTE SETUP button to exit the preset recall setup mode. The remote control and receiver return to their previous operation modes. 59 BASIC