Pioneer VSX-43TX Owner's Manual - Page 60
Programming Signals from Other Remote Controls LEARNING Mode
View all Pioneer VSX-43TX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
Remote Control of Other Components Programming Signals from Other Remote Controls (LEARNING Mode) If preset codes are not available for your component(s), or the available preset codes do not operate correctly, you can use this procedure to program in signals from the remote control(s) of your other component(s). These steps can also be used to add further operations to the remote control that were successfully set with the stored settings (see page 59). memo • To exit from the remote control setup mode at any time, press REMOTE SETUP. • You can also program the 5˜∞˜2˜3 and ENTER buttons with the LEARNING mode. • The TUNER button cannot be assigned. • Some commands cannot be learned. 2 60 RECEIVER MULTI SYSTEM SOURCE OPERATION OFF DVD/LD MULTI CONTROL TV / SAT VCR/DVR TV CONT VCR 2 CD TUNER MOVIE MUSIC ACOUSTIC EQ RECEIVER INPUT SURROUND MODE SB CH MULTI CH MODE INPUT STEREO/ DIRECT ENTER MIDNIGHT MUTE MASTER VOLUME MENU TUNER EDIT TOP MENU SYSTEM SETUP ST AUDIO TUNE GUIDE ST ENTER TUNE RETURN − + CHANNEL DTV ON/OFF BAND CHANNEL D.ACCESS MPX CLASS DIMMER LOUDNESS TONE EFFECT/CH SEL ENTER SIGNAL SEL DNR BASS/TREBLE DISC VIDEO SEL HI-BIT +− +10 TV CONTROL SUB TITLE INPUT SELECT CHANNEL VOLUME REMOTE SETUP RECEIVER LED 1 While holding down the REMOTE SETUP button press to select the learning setup mode. The LED begins to blink. To cancel the learning setup mode press REMOTE SET UP. Buttons that are 3 able to learn new commands 1 2 Press the MULTI CONTROL button for the component you want to control. The LED lights continously. 3 Press the button to be programmed. For example DVD/LD The LED blinks rapidly. • The TV , TV INPUT SELECT, TV CHANNEL +/- and TV VOLUME +/- buttons are only available for learning when programming TV CONTROL operations. 4 Point the remote controls at each 1 other and press the button on the other remote control for the operation you wish to program . RECEIVER MULTI SYSTEM SOURCE OPERATION OFF MULTI CONTROL DVD/LD TV / SAT VCR/DVR TV CONT VCR 2 MOVIE SURROUND MODE CD MUSIC STEREO/ DIRECT ENTER MIDNIGHT MASTER VOLUME MENU TUNER EDIT SYSTEM SETUP ST AUDIO CHANNEL TUNE TUNER ACOUSTIC CAL SB CH MULTI CH MODE INPUT ST ENTER TUNE − DTV ON/OFF BAND + CHANNEL RF ATT D.ACCESS DIMMER LOUDNESS TONE EFFECT/CH SEL SIGNAL SEL DNR BASS/TREBLE VIDEO SEL HI-BIT INPUT SELECT TV CONTROL CHANNEL RECEIVER MPX VOLUME RECEIVER INPUT MUTE TOP MENU GUIDE RETURN CLASS ENTER +− +10 SUB TITLE REMOTE SETUP DISC 2-8 inches 1 Point the remote controls toward each other. 2 Press the button on the other remote control corresponding to the operation you wish to program. The LED will turn off and then light again. To program additional operations for the current component, repeat steps 3 and 4. To program operations for another component, repeat steps 2 through 4. 5 Press the REMOTE SETUP button to exit the learning setup mode. The remote control and receiver return to their previous operation modes.