Ricoh 2238 Operating Instructions - Page 138

User Tools (Copier/Document Server Features) Input/Output ❖ Switch to Batch (SADF) You can select to have the Batch or SADF function displayed when you press [Special Original]. See p.15 "Batch". ❖ Auto Sort You can specify whether the Sort function is to be selected when the machine is turned on, or when the functions are cleared. Note ❒ Default: No Note ❒ Default: Batch ❖ Memory Full Auto Scan Restart If memory becomes full while scanning originals, the machine ❖ SADF Auto Reset In SADF mode, an original must be set within a specific time after the previous original has been fed. You can adjust this time from 3 sec- will copy the scanned originals first, and then automatically proceed scanning remaining originals. You can enable or disable this function. 5 onds to 99 in 1 second increments. Note Note ❒ If you select [No] : ❒ Default: 5 seconds ❖ Rotate Sort: Auto Paper Continue You can continue copying when paper of the required orientation has run out during rotate-sorting. See p.43 "Rotate Sort". Note ❒ If you select [No] : • When memory becomes full, the machine stops operation, allowing you to remove the copies on the output tray. ❒ If you select [Yes] : • You can leave the machine unattended to make copies, but sorted pages will not be sequential. • When paper of the required orientation runs out, the machine stops copying and prompts you to supply copy paper. When you load paper, the machine will continue copying. ❒ If you select [Yes] : • Copying continues using copy paper of a different orientation. The copy job will finish even if the machine is left unattended. ❒ Default: No ❖ Select Stack Function Specify whether Stack or Rotate Sort has priority on the initial display. Note ❒ Default: Stack ❒ An 2 tray finisher or booklet fin- isher is required to use this function. ❒ Default: No 124