Ricoh 2238 Operating Instructions - Page 36

Copying Copying from the Bypass Tray Use the bypass tray to copy onto spe- ❒ When copying onto OHP transpar- cial paper such as OHP transparen- encies or paper heavier than 128 cies, thick paper, thin paper, and copy g/m2 (about 34 lb.), you need to paper that cannot be loaded in the pa- specify the paper type. See p.24 2 per trays. "When copying onto OHP Transparencies or Thick Paper". Preparation When copying from the bypass tray, select [1 Sided] for copying in [Dup./Combine/Series] (for example ❒ You must specify the paper size when using paper (tracing paper, etc.) of less than 59g/m2 thickness. [1 Sided] → [1 Sided].) ❒ The maximum number of sheets you can load at one time depends Note on paper type. The maximum ❒ The machine can automatically de- number of sheets should not ex- tect the following sizes as standard ceed the upper limit. size copy paper: ❒ Some kinds of envelopes might Metric A3L, A4L, A5L, B4 JISL, version B5 JISL, B6 JISL cause misfeed and wrinkle. If this happens, push down the fusing Inch 11" × 17"L, 81/2" × 11"L, version 51/2" × 81/2"L unit's green lever. See p.26 "When copying onto envelopes". Also, be sure to place the front face of the ❒ Select the paper size when making envelope downward. horizontal copies. ❒ Paper of 433 mm in length, or larg- ❒ If you use non-standard size copy er, is likely to jam, crease, or not paper or special paper, you should feed in properly. A input its vertical and horizontal di- mensions directly. See p.17 "Plac- Open the bypass tray. ing custom size originals". The sizes you can input are as follows: Metric • Vertical: 90.0 - 305.0 mm version • Horizontal: 148.0 - 457.2 mm Inch • Vertical: 3.55" - 12.00" version • Horizontal: 5.83" - 18.00" ZKVH120J 22