Ricoh 3035 Printer Reference - Page 19

Setting Paper on the Bypass Tray Setting Paper on the Bypass Tray This section gives instructions for setting paper on the bypass tray. Use the bypass tray to print onto OHP transparencies, labels, thick paper, and envelopes that cannot be loaded in the paper tray. Reference For details about setting paper in 1 the regular paper tray, see General Settings Guide. When loading custom size paper, see p.15 "Setting Custom Size Pa- Important per". ❒ The following functions are disabled when printing from the bypass tray: When loading OHP transparencies or thick paper (over 127.9 g/m2), • Duplex printing set paper size and paper type. For • Auto Tray Select • Auto Tray Switching • Rotating Collate details, see p.16 "Setting Thick Paper or OHP Transparencies". When loading letterhead paper, pay attention to its orientation. See • Staple (when the optional unit is "Orientation-Fixed Paper or Two- installed) Sided Paper", General Settings • Punch (when the optional unit Guide. is installed) ❒ When printing using the printer function, original images are always rotated by 180 degrees (the orientation of images to be printed is opposite to that of the copier Note ❒ Paper within the following dimen- sions can be set in the bypass tray: • Vertical: 100 - 297 mm (4.0 - 11.7 in.) function). When printing onto pa- • Horizontal: 148 - 600 mm per with specific orientation re- (5.9 - 23.7 in.) quirements, such as envelopes and letterheads, make sure to rotate the paper feed orientation to 180 degrees. ❒ Be sure to set the paper with the side you want to print facing down in the bypass tray. ❒ The number of sheets that can be loaded in the bypass tray depends on the paper type. ❒ Paper sizes fed from the bypass tray are output first sheet down, print side-up. 13