Ricoh AP2610 Setup Guide - Page 53

3. Configuring the Printer for the Network Make the network settings below depending on the network interface you use. • Parallel/USB: Making network settings is not necessary. Go to p.51 "Install- ing the Printer Driver and Software". • Ethernet: Make the settings in p.41 "Ethernet Configuration", and then see p.51 "Installing the Printer Driver and Software". • IEEE 1394: Make the settings in p.45 "IEEE 1394 Configuration", and then see p.51 "Installing the Printer Driver and Software". • Wireless LAN: Make the settings in p.48 "IEEE 802.11b (Wireless LAN) Con- figuration", and then see p.51 "Installing the Printer Driver and Software". Note ❒ The optional Network Interface Board is necessary to use Ethernet with Basic model printer. ❒ The optional 1394 Interface Unit is necessary to use IEEE 1394. ❒ The optional 802.11b Interface Unit is necessary to use the wireless LAN. Ethernet Configuration Configure the printer for the network using the printer's control panel. The following table shows the control panel settings and their default values. These items are included in the "Host Interface" menu. Reference For information about configuring the computer for the network, see the Network Printing Guide on the CD-ROM labeled "Operating Instructions". For information about "Host Interface" menu, see "Host Interface Menu" in the Printer Reference on the CD-ROM labeled "Operating Instructions". Setting Name Value IP Address 011.022.033.044 Subnet Mask 000.000.000.000 Gateway Address 000.000.000.000 Network Boot None Frame Type (NW) Auto (Frame type NetWare) Active Protocol TCP/IP ❍ *1 NetWare ❍ *1 NetBEUI ❍ *1 AppleTalk ❍ *1 Ethernet *2 Auto LAN Type *3 Ethernet *1 ❍ means that this protocol is active. *2 Make this setting only when it is nec- essary. *3 Appears only when both the Network Interface Board and the 802.11b Interface Unit are installed. 41