Ricoh AP2610 Setup Guide - Page 60
IEEE 802.11b (Wireless LAN) Configuration, Host Interface, I/O Buffer, IEEE 802.11b, Comm. Mode
UPC - 026649007576
View all Ricoh AP2610 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
Configuring the Printer for the Network IEEE 802.11b (Wireless LAN) Configuration Configure the printer for using the wireless LAN. The following table shows the control panel settings and their default values. These items are included in the "Host Interface" menu. B Press {U} or {T} to display "Host Interface" menu. Menu: Host Interface Setting Name Value 3 Comm. Mode Ad hoc Channel • Inch version (1-11) 11 • Metric version (1-13) 11 Trans. Speed Auto WEP Settings Not Active C Press {Enter #}. On Line Menu Job Reset Escape Form Feed Enter In order to use the wireless LAN, select "IEEE 802.11b" for "LAN Type" in "Network Setup" of the Host Interface menu, and then set "IP Address", "Subnet Mask", "Gateway Address", "Network Boot", "Frame Type (NW)" and "Active Protocol" in the "Network Setup". For more information about setting the items in the "Network Setup", see p.41 "Ethernet Configuration". A Press {Menu}. On Line Menu Job Reset Escape Form Feed Enter Power Error Data In ZFDP020N Power Error Data In ZFDP060N The following message appears on the panel display. Host Interface: I/O Buffer D Press {U} or {T} to display "IEEE 802.11b". Host Interface: IEEE 802.11b E Press {Enter #}. Be sure that "Comm. Mode" appears on the panel display. IEEE 802.11b: Comm. Mode "Menu" appears on the panel display. 48