Ricoh MP161SPF General Settings Guide - Page 18
Connecting to the Ethernet Interface, Make sure the main power switch of the machine is off.
View all Ricoh MP161SPF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Connecting the Machine Connecting to the Ethernet Interface This section describes how to connect 10BASE-T or 100BASE-TX cable to the Eth- 1 ernet interface. Important ❒ If the main power switch is on, turn it off. A A ferrite core for the Ethernet cable is supplied with this machine. Make a loop in the cable about 3 cm (1.2 inch) (1) from the machine end of the cable. Attach the ferrite core. ARH009S B Make sure the main power switch of the machine is off. C Connect the Ethernet interface cable to the 10BASE-T/100BASE-TX port. ARH005S D Connect the other end of the Ethernet cable to a network connection device such as a hub. 8
Connecting the Machine
8
1
Connecting to the Ethernet Interface
This section describes how to connect 10BASE-T or 100BASE-TX cable to the Eth-
ernet interface.
Important
❒
If the main power switch is on, turn it off.
A
A ferrite core for the Ethernet cable is supplied with this machine. Make a
loop in the cable about 3 cm (1.2 inch) (1) from the machine end of the cable.
Attach the ferrite core.
B
Make sure the main power switch of the machine is off.
C
Connect the Ethernet interface cable to the 10BASE-T/100BASE-TX port.
D
Connect the other end of the Ethernet cable to a network connection device
such as a hub.
ARH009S
A
RH005
S