Ricoh MP161SPF General Settings Guide - Page 63
IEEE 802.11b, Communication Mode, SSID Setting, Channel, Security Type, Wireless LAN Signal
![]() |
View all Ricoh MP161SPF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
Interface Settings IEEE 802.11b This section describes various items of [IEEE 802.11b] under [Interface Settings]. This section describes the user tools in the IEEE 802.11b menu under Interface Settings. [IEEE 802.11b] is displayed when this machine is installed with the wireless LAN interface board. Be sure to make all settings simultaneously. 2 ❖ Communication Mode Specifies the communication mode of the wireless LAN. The default setting is 802.11 Ad hoc. ❖ SSID Setting Specifies SSID to distinguish the access point in infrastructure mode or 802.11 ad hoc mode. The characters that can be used are ASCII 0x20-0x7e (32 bytes). If blank is specified in 802.11b ad hoc mode or ad hoc mode, "ASSID" appears. ❖ Channel The default setting is 11. The following channels are available: 1-14 (Metric version) / 1-11 (Inch version) ❖ Security Type Specifies the encryption of the IEEE 802.11b (wireless LAN). If you select [WEP], always enter WEP key. If you select [WPA], specify the encryption and authentication methods. Specify "WPA", when [Communication Mode] is set to [Infrastructure]. The default setting is Off. • Off • WEP • WPA • Encryption Method Select either "TKIP" or "COMP(AES)". • Authentication Method Select either "WPA-PSK" or "WPA(802.1X)". If you select "WPA-PSK", enter the pre-shared key (PSK) using 8-63 ASCII characters. ❖ Wireless LAN Signal When using in infrastructure mode, you can check the machine's radio wave status using the control panel. Radio wave status is displayed when you press [Wireless LAN Signal]. ❖ Communication Speed Specifies the communication speed of the IEEE 802.11b (wireless LAN). The default setting is Auto. 53
![](/manual_guide/products/ricoh-mp161spf-general-settings-guide-73ece8e/63.png)