Sanyo PDG-DWL100 RS232C Expand - Page 14

PDG-DWL100 Expand Serial Command Functional Specifications 8 Functional Execution CommandFormat ①PC issues a command in the format below: Pattern1: "CF_Command" [CR] Pattern2: "CF_Command_" %1 [CR] CF_: Header Command: Text %1: Parameter (Text) _: Space (To separate Command and Parameter) ①The projector decodes the received command and when it gets ready to receive another command, it returns the Correspondence. "000" [CR]: (0x06, 0x0D) When the projector receives the Functional Execution Command. "nnn" [CR]: Except "000", when it cannot execute commands for some specific reason. Refer to [7. Error Code Table] for detail. ①When the projector cannot decode the command, it returns "?" [CR]. 8.2 Transfer Example When setting projector's total dots to 1344 by Expand Command. PC → PJ: "CF_TDOTS_1344" [CR] PC ← PJ: "000" [CR Acceptable 8.3 Operation Requirements Functional Execution Commands are limited in the status bellow/ (Status Read Commands are available in following status.) Projector Status Available Functional Execution Command In Standby Mode C00: POWER ON Cooling Down in process NONE (No Execution) Cooling Down in process abnormal temperature due to NONE (No Execution) In Abnormal Temperature NONE (No Execution) Power Failure (For 60 seconds after Power failed.) NONE (No Execution) Note) The projector returns an appropriate error code when it receives other command in the above status. 14 / 47