Sanyo PDG-DWL100 RS232C Expand - Page 23
Lamp Command, CF_LAMPH Command, CF_LAMPMODE Command
UPC - 086483074875
View all Sanyo PDG-DWL100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
PDG-DWL100 Expand Serial Command Functional Specifications 8.8 Lamp Command 8.8.1 CF_LAMPH Command Command "CF_LAMPH_%1"[CR] %1 "RST" Details Reset total lamp running time This command is available in normal Power ON status. Acceptable Acceptable Correspondence Unacceptable Unacceptable 8.8.2 CF_LAMPMODE Command Command "CF_LAMPMODE_%1" [CR] %1 "ON Set lamp control mode to ECO "OFF Set lamp control mode to NORMAL Details Select Eco mode. (Valid only when in the normal Power ON status.) The value set by this command is stored in EEPROM and the setting remains effective after the power is turned to ALL OFF status. No display is shown when projector received command.. Acceptable "000" [CR] Correspondence Unacceptable "Error Code" [CR] 23 / 47
PDG-DWL100
Expand Serial Command Functional Specifications
23 / 47
8.8
Lamp Command
8.8.1
CF_LAMPH Command
Command
“CF_LAMPH_%1”[CR]
%1
“RST”
Details
Reset total lamp running time
This command is available in normal Power ON status.
Correspondence
Acceptable
Acceptable
Unacceptable
Unacceptable
8.8.2
CF_LAMPMODE Command
Command
“CF_LAMPMODE_%1” [CR]
%1
“ON” ---------------------------- Set lamp control mode to ECO
“OFF” --------------------------- Set lamp control mode to NORMAL
Details
Select Eco mode. (Valid only when in the normal Power ON status.)
The value set by this command is stored in EEPROM and the setting
remains effective after the power is turned to ALL OFF status.
No display is shown when projector received command..
Correspondence
Acceptable
“000” [CR]
Unacceptable
“Error Code” [CR]