Sanyo PDG-DWL100 RS232C Expand - Page 22

PDG-DWL100 Expand Serial Command Functional Specifications 8.7 Screen Control Command 8.7.1 CF_SCREEN Command Command "CF_SCREEN_%1" [CR] "NORMAL Select 4:3 screen display "WIDE Select 16 10 screen display %1 "TRUE Select native screen display "UP Switch screen upward "DN Switch screen downward Details Select screen size. (Valid only when in the normal Power ON status.) The projector shows Image OSD at receiving the command. Acceptable "000" [CR] Correspondence Unacceptable "Error Code" [CR] 8.7.2 CF_KEYSTONE Command Command "CF_KEYSTONE _%1" [CR] "UP Correct Keystone distortion to resize upper part of image "FUP Correct Keystone distortion to resize upper part largely %1 "DN Correct Keystone distortion to resize lower part of image "FDN Correct Keystone distortion to resize lower part largely "RST Reset keystone adjust Details Change the correction level of Keystone distortion. (Valid only when in the normal Power ON status.) When the value reaches the correction limit, the projector accepts the command but does not execute it. The behavior is the same as the "Keystone +/-" button of the remote control A scale OSD is shown by adjusting Keystone and the scale reflects adjusting value Acceptable "000" [CR] Correspondence Unacceptable "Error Code" [CR] 8.7.3 CF_MOUNTING Command Command "CF_MOUNTING_%1" [CR] "FDESKTOP Select Front-Desktop %1 "RDESKTOP Select Rear-Desktop "FCEILING Select Front-Ceiling "RCEILING Select Rear-Ceiling Details Select Mounting mode. (Valid only when in the normal Power ON status.) Acceptable "000" [CR] Correspondence Unacceptable "Error Code" [CR] 8.7.4 CF_DZCENT Command Command "CF_DZCENT_%1" [CR] %1 "CENT Cancel Digital Zoom CENT "CENTER Details Cancel Digital Zoom When image is expanded or shrunk, reset its value. (Valid only when in the normal Power ON status.) Acceptable "000" [CR] Correspondence Unacceptable "Error Code" [CR] 22 / 47