Sanyo PDG-DWL100 RS232C Expand - Page 6

PDG-DWL100 Expand Serial Command Functional Specifications 1 Overview This Functional Specification defines communication with Network board for PDG- DWL100. Commands are designed to Network communication, but most commands are also available to remote-control a projector through RS-232C from a computer. Therefore, commands are defined as Expand Serial Commands. The operation by some commands depends on Input or Source of the projector. 2 Serial Interface Specification 2.1 Transfer Specification Items Specification Synchronous System Asynchronous Transmission Speed Data Length Parity Stop Bit Flow Control 9600/19200 8 bit N/A 1 N/A 1) Transmission Speed: Initial setting value is 9600. 2) Transmission Speed can be changed in service mode. 2.2 Connection Use the dedicated serial cables for the connection between a computer and the projector. PC Projector COM 1 Serial Port IN Connect COM port of the computer to SERIAL PORT IN of the projector. COM Port (COM1 or COM2) of a computer is specified by the control software of the computer. 6 / 47