Sharp BD-HP25U BD-HP25U Operation Manual - Page 22

Playback Before Starting Playback Loading the Batteries in the Remote Control 1 Hold in the tab on the battery cover and pull the cover towards the direction of the arrow. 2 Load the two "AA" size batteries (R-06 size, UM/SUM-3). Place batteries with their terminals corresponding to the m and n indications in battery compartment. NOTE • Do not subject the remote control unit to shock, water or excessive humidity. • The remote control unit may not function if the Player's remote sensor is in direct sunlight or any other strong light. • Incorrect use of batteries may cause them to leak or burst. Read the battery warnings and use the batteries properly. • Do not mix old and new batteries, or mix different brands. • Remove the batteries if you will not use the remote control unit for an extended period of time. Approximate operating range of remote control Remote control sensor 3 Insert the smaller tab of the battery cover into the opening 1, and press down on the cover until it clicks in place 2. 15º 30º 30º 15º *Approx. 22 feet (7m) Connecting the Power Cord Plug the supplied AC cord into the AC IN terminal on the rear of the Player (1). Then plug into AC outlet (2). NOTE • Place the Player close to the AC outlet, and keep the power plug within reach. • TO PREVENT RISK OF ELECTRIC SHOCK, DO NOT TOUCH THE UN-INSULATED PARTS OF ANY CABLES WHILE THE AC CORD IS CONNECTED. • The POWER (ON/STANDBY) indicator blinks while the Player is preparing for starting up. You cannot turn the Player on until the POWER (ON/STANDBY) indicator stops blinking. • If you are not going to use this Player for a long period of time, be sure to remove the AC cord from the AC outlet. WARNING • Do not use or store batteries in direct sunlight or other excessively hot place, such as inside a car or near a heater. This can cause batteries to leak, overheat, explode or catch fire. It can also reduce the life or performance of batteries. 20 Remote control unit