Sharp MX-M314N Operation Guide - Page 174
Place the original., Select the special modes., Set the tab width., Load the tab paper., Press the [
View all Sharp MX-M314N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 174 highlights
COPIER 1 Place the original. Place the original face up in the document feeder tray, or face down on the document glass. Select the special modes. 2 (1) Touch the [Special Modes] key. (2) Touch the [Tab Copy] key. Special modes menu (1st screen) (page 2-38) Special Modes Tab Copy (1) (2) OK Cancel OK 3 Original Copy Image Shift 10 (0~20) mm Set the tab width. (1) Set the image shift width (tab width) with the keys. 0 mm to 20 mm (0" to 5/8") can be entered. You can also directly touch a numeric value display key to change a number with the numeric keys. (2) Touch the [OK] key. You will return to the base screen of copy mode. Load the tab paper. Reverse side When using the bypass tray, place the paper with the print side down. Place the paper so that the sides with the tabs enter the machine last. 4 After loading the tab paper, configure the bypass tray settings as explained in "MAKING COPIES USING THE BYPASS TRAY" (page 2-35). The width of the tab paper can be as wide as A4 width (210 mm) plus 20 mm (or 8-1/2" x 11" paper (8-1/2") plus 5/8"). Press the [START] key. Copying will begin. If you are using the document glass to copy multiple original pages, copying will take place as you scan each original. If you 5 have selected sort mode, change originals and press the [START] key. Repeat until all pages have been scanned and then touch the [Read-End] key. To cancel scanning and copying... Press the [STOP] key ( ). To cancel tab copy... Touch the [Cancel] key in the screen of step 3. System Settings (Administrator): Initial Tab Copy Setting The default image shift width can be set from 0 mm to 20 mm (0" to 5/8"). The factory default setting is "10 mm (1/2")". 2-76 Contents