Sharp MX-M314N Operation Guide - Page 756

Open the fusing unit paper guide by pushing down its protrusion, and carefully remove the misfed paper. TROUBLESHOOTING (4) Paper misfeed in the right tray Gently open the right tray cover. Remove the misfed paper. Caution The fusing unit is hot. Do not touch it when removing misfed paper, as it may cause burns and injuries. • When removing paper, do not touch the photoconductive drum (the green part), as it will scratch the drum and cause specks in the copies. • Since the removed paper has unfused toner on it, use caution to avoid soiling your hands or clothing. • Do not open the cover for a long time, so that the photoconductive drum is not exposed to light. (4) Paper misfeed in the upper exit area (when a job separator/finisher (MX-FN23) is installed) A paper misfeed may occur in the upper exit area when outputting to the job separator or the finisher. Gently open the upper cover. Remove the misfed paper. (5) Paper misfeed in the bypass tray Remove the misfed paper. Hold the handle for opening/closing the side cover, and gently open and close the side cover. (6) Paper misfeed in tray 1 to tray 4 Before pulling the tray out, make sure that there is no misfed paper in the machine. Open the bypass tray, and while holding the handle for opening/closing the side cover, pull out the side cover. Remove the misfed paper. 8-10 Contents